REMAP CHIP GUIDE

Unlock advanced control with our PS5 Remap Chip Guide. This page walks you through how the remap chip works, what it enables, and how to use it to customize your controller inputs for faster, more responsive gameplay. From installation details to feature explanations and troubleshooting tips, this guide gives you everything you need to get the most out of your remapped PS5 controller with clarity and confidence.

How to reprogram the rear buttons: 

*Disclaimer, please note the
LED may not work on every remap chip, but the function of the remap chip is not
affected.

1. Programmable Remapper

Using the PS5 Programmable Remapper:

  • In order to use the rear back buttons/ paddles, you must first Enter the “programming” mode.
  • To do this, the following key combination must be held together, as long as possible, until the LED lights up continuously white (about 3 seconds): L1 + R1 + square + D-pad right Then you hold the back button/ paddle button and the Controller button you want to map at the same time, until the indicator LED goes out (about 3 seconds)

  • After the LED went out, the button/ paddle has been mapped, and you then need to repeat this step to map the other buttons/ paddle buttons.

2. Using Pre-set mode:

Saving Presets:

  • So that you can quickly switch between different back button mappings on the fly, pre-sets can be saved.
  • You can save up to 4 Presets.
  • To do this, the following key combination must be held together, as long as possible, until the LED lights up continuously white (about 3 seconds) L1 + R1 + triangle + D-pad Right
  • Then you hold either: X, O, triangle or the square button until the indicator LED stops blinking.
  • You then need to follow step 1 above to set your back buttons for your preset.
  • A preset can be saved on each of the four Face buttons mentioned.
  • For example, you can save a different preset under X, Circle, Square and Triangle.

Switching Presets:

  • To switch between presets, you will need to hold L1 + R1 + triangle + D-pad Right, until the LED lights up continuously white (about 3 seconds)
  • Then you hold either: X, O, triangle or the square button until the indicator LED stops blinking. For example, if you have held down X, you have now chosen the X preset back button mapping, follow the step to change to the Circle, Triangle or Square presets.

If you need any assistance, please call, use store chat or whatsapp, email us at support@novacontrollers.com